Fireblade master cylinder on CBR pre'97 bike?

[Andrei "The Russian"]

Had this posted in the workshop section but got no replyes so i thought better try here.
Looking to improve my brakes and thought of fitting master cylinder fron blade 2000. Does any one know if the banjo bolt would fit?
Also any one who is racing in pre'97, what master sylinder are ye using (not brembo - too pricee) and also what brake pads.
Thanks.

[tocr]

any radial yamaha masters are very good!! 2006 on from r6 or r1 are brembo.

[Andrei "The Russian"]

To view pics on this biker's forum - your post count must be 2 or greater.
any good
or
To view pics on this biker's forum - your post count must be 2 or greater.

or
To view pics on this biker's forum - your post count must be 2 or greater.

And would Yamaha defo fit? Any input is appriciated.
Cheers.

[illeagles-mcc]

Originally Posted by Andrei "The Russian"

To view pics on this biker's forum - your post count must be 2 or greater.
any good
or
To view pics on this biker's forum - your post count must be 2 or greater.

or
To view pics on this biker's forum - your post count must be 2 or greater.

And would Yamaha defo fit? Any input is appriciated.
Cheers.

that is what i have on my bike it makes a good difference would recommend it

[Andrei "The Russian"]

Originally Posted by illeagles-mcc

that is what i have on my bike it makes a good difference would recommend it

And what bike did you fit the above too? was it HONDA?

[illeagles-mcc]

Originally Posted by Andrei "The Russian"

And what bike did you fit the above too? was it HONDA?

yep a 94 honda,the master cylinder was off my old 96 cbr 900 stuntbike,just put braided lines in and good pads and quality brake fluid and your brakes will be good for the class,no need to change to different calipers or anything

[Andrei "The Russian"]

Cool. Cheers. Might try to get newer Blade master cylinder. Not too expensive on ebay.
They also have some R1 master cylinder, might get that insted.

[tocr]

Originally Posted by Andrei "The Russian"

To view pics on this biker's forum - your post count must be 2 or greater.
any good
or
To view pics on this biker's forum - your post count must be 2 or greater.

or
To view pics on this biker's forum - your post count must be 2 or greater.

And would Yamaha defo fit? Any input is appriciated.
Cheers.

yes yam will fit. only problem is the bajo bolt needed may have a different pitch thread but there only a few euro. But 99% of the time there the same.

[Andrei "The Russian"]

Cheers. I actualy ordered CBR Fireblade 2000 master cylinder. Now just need new race pads and brakes are sorted.