Bandit Chinese Ignition Switch Not Working

[CarolVordermansGearbox]

After waiting ages for it to arrive it doesn't seem to be working..

Heard about a Resistor that has to be added, anybody do this before?

Cheers!

[eyore]

The clue to the problem could be the word Chinese.

[CarolVordermansGearbox]

Originally Posted by eyore

The clue to the problem could be the word Chinese.

Afraid so! Terminals inside aren't lining up properly when the key is turned 🙄 Can do it by hand ..

[CarolVordermansGearbox]

Anybody any idea what wires to put the 100 ohm resistor across so it sparks??

[speedy joe]

with the leads off the switch check it with a meter and see if there is continiuty between the terminals when you turn the key

[CarolVordermansGearbox]

When I turn the key to on the Parked light comes on.. when I turn the key past the handlebar lock to where the parked light should be the oil and neutral light come on.. ��

[DavyH]

And that's why cheap Chinese parts are shite

[pedrosixfour]

Is it a multi-socket that plugs into the back of the switch or are the ignition wires loose?
It sounds like the wires aren't connected to the correct terminals, but with a multi-socket that shouldn't be possible. Unless the socket can be fitted to the switch in more than one position.

[chopper]

sounds like the plugs wired up wrong

[CarolVordermansGearbox]

Cheers lads. Nothing seems to be easy for me the last few weeks!

Sent on pictures to the eBay seller, hopefully they notice something wrong in the wiring.

[CarolVordermansGearbox]

Originally Posted by pedrosixfour

Is it a multi-socket that plugs into the back of the switch or are the ignition wires loose?
It sounds like the wires aren't connected to the correct terminals, but with a multi-socket that shouldn't be possible. Unless the socket can be fitted to the switch in more than one position.

It's a 6 wire multi. Fit perfectly into the original harness and can't go in upside down because of a catch on the male socket.

[lpeare]

Originally Posted by CorkBandit

Anybody any idea what wires to put the 100 ohm resistor across so it sparks??

you are correct on most Suzuki there is a resistor .Google will tell you where it should be

[pedrosixfour]

Originally Posted by CorkBandit

It's a 6 wire multi. Fit perfectly into the original harness and can't go in upside down because of a catch on the male socket.

Figured as much.

I'm out!