paddock stand bobbins. CBR600 01

[YETIBOY]

Howya lads, my 01 CBR600 does not have holes on the swing arm for bobbins for a paddock stand, I got an oxford stand with the rubber L shaped holders but the bike keeps sliding of the stand!!

So my question... is it possible to weld on or drill into the swing arm to attach bobbins??

thanks lads.
To view pics on this biker's forum - your post count must be 2 or greater.

[N11 EXPRESS]

just glue some rubber to the plate on the stand

[stiggy]

yeh or ya could go down this route either... only if your rich a course


To view pics on this biker's forum - your post count must be 2 or greater.


To view pics on this biker's forum - your post count must be 2 or greater.



To view pics on this biker's forum - your post count must be 2 or greater.

[Scarfaceracing#163]

Originally Posted by YETIBOY

Howya lads, my 01 CBR600 does not have holes on the swing arm for bobbins for a paddock stand, I got an oxford stand with the rubber L shaped holders but the bike keeps sliding of the stand!!

So my question... is it possible to weld on or drill into the swing arm to attach bobbins??

thanks lads.
To view pics on this biker's forum - your post count must be 2 or greater.

Yeh !! Drill and tap the swingarm, ders enuf meat to get a good fixing ! I have done it on 1 of my race bikes !
To view pics on this biker's forum - your post count must be 2 or greater.

[ruane]

rubber band around the front brake lever.. wont fix the grip issue, but may stop her sliding off the stand

[LittleBlackBlade]

yes Ive done it loads of times!
on the solid alloy block the spindle goes threw you will fit a 6mm hole comfy at the bottom front corner just beside the weld!