|
|
#1
10th September 2010, 05:29 PM
|
||||
|
||||
Wiring a new speedo
Just got a GSXR speedo for my trackbike. There was a scitsu tacho in it but it broke. I had 3 wires in the old one, positive, negative and the one to give the rev reading. I've just noticed that theres only a plug into the back on the gsxr one. Its a K3 600.
Does anyone know if this unit will even work? I only want the rev counter to work. I cant seem to find the pin layout either to wire it direct to the plug! Kinda stuck for time as I want it for the track day on Monday. Any help or advice would be great. Thanks To view pics on this biker's forum - your post count must be 2 or greater. 
|
|
#4
10th September 2010, 08:28 PM
|
||||
|
||||
|
Re: Wiring a new speedo
that'd be a six hunderd im thinkin, ill see can i find some wirin diagrams an ill get back to you
|
|
#5
12th September 2010, 09:58 AM
|
||||
|
||||
|
Re: Wiring a new speedo
This is as good as i can get for ya at the minute, seems like every one of them is wired differently
TOP from left to right lookin at back of clocks Orange w/ Dark green Stripe Red w/ White Stripe Black w/ yellow Stripe Light Green Solid Black Solid Dark Green w/ Yellow Stripe Black w/ Green Stripe Black w/ Red Stripe bottom Light Grey Solid Black w/ White Stripe Dark Blue w/Black Stripe Orange w/ Red Stripe Black w/ White Stripe Black w/ Light Green Stripe Red w/ Black Stripe Pink Solid
|
|
#6
12th September 2010, 02:58 PM
|
||||
|
||||
|
Re: Wiring a new speedo
Thanks a mill, I'll try it & let ya know!
To view pics on this biker's forum - your post count must be 2 or greater.
|
